Did you know?

Even with a properly installed refrigerated air dryer located at or near the air compressor site, the fact that your plumbing is exposed to the changes in temperature will allow moisture to reappear along this route.  Even worse is when the plumbing is allowed to sag or have low spots to drop around a structure or object.  This low spot will, over time fill with moisture, and perhaps compressor oils, that at some point will move down stream into your pneumatic tool, or spray paint application, all at one time.  The best advice to make sure this does not happen is to install a properly sized compressed air filter at the point of use.


Download PDF of this page  Print this page

Magnetic Gun Supporter


Magnetic supporter for spray guns with gravity cups.
It also can be fixed on non-ferrous surfaces with the supplied screws.

1 piece per package

$25.00 Each

Only 2 Left

Shipping charge of $14.95 for one holder

7.8" x 9.1" x 5.7"

All Sales are Final on Bargain Area Items



Site Map | Site Credits: Ecreativeworks