Did you know?
Even with a properly installed refrigerated air dryer located at or near the air compressor site, the fact that your plumbing is exposed to the changes in temperature will allow moisture to reappear along this route. Even worse is when the plumbing is allowed to sag or have low spots to drop around a structure or object. This low spot will, over time fill with moisture, and perhaps compressor oils, that at some point will move down stream into your pneumatic tool, or spray paint application, all at one time. The best advice to make sure this does not happen is to install a properly sized compressed air filter at the point of use.
Home » Electronic Drains
Walmec North America offers commercial grade electronic drains. Our custom electronic drains are made from brass materials. The electronic drains work from 120 AC power and draw low amperage. Each electronic drain can be set for duration of open/close and also for how often they open and close.
Walmec North America electronic drains have a variety of uses. These drains are available in 1/8”, 1/4”, 3/8”, 1/2” NPT sizes. They can be installed as the auto drain on a storage tank. They can be installed at the bottom of a drip leg and they can be installed anywhere collected liquids need to be expelled.
Our high quality electric drains are designed to operate at pressures up to 300 PSI. The compact design allows this custom drain to fit in the tightest of locations. Choose the right drain for your equipment or contact Walmec North America with any questions you may have.