Did you know?
Even with a properly installed refrigerated air dryer located at or near the air compressor site, the fact that your plumbing is exposed to the changes in temperature will allow moisture to reappear along this route. Even worse is when the plumbing is allowed to sag or have low spots to drop around a structure or object. This low spot will, over time fill with moisture, and perhaps compressor oils, that at some point will move down stream into your pneumatic tool, or spray paint application, all at one time. The best advice to make sure this does not happen is to install a properly sized compressed air filter at the point of use.
Walcom FX and FZ Paint Guns
The GEO System, born to exploit in the best way the bond of pressure equal to 10 PSI dictated from the HVLP system, allows to obtain a degree of the product's application better than the conventional one for the consumption and degree of finish. By exploiting the dual atomization of the product due to the particular design ofthe nozzle, the GEO System allows a high level application with all types of old and new generation paints.
The advantages of GEO are:
- Excellent finish
- Transfer efficiency of above 70% as tested by leading Italian and European regulatory authorities
- Low air consumption of the spray gun
- Less clogging of the filter in the spray booth, for the benefit of user's health and the environment
- Compliance with environmental regulations (HVLP)